Over the last several months, I have been helping out in a small way with WFUV’s new transmitter installation. George Evans, CE for WFUV, and Bill Weeks of Wolftron Electronics did most of the work. This project’s location is unique; the transmitter is in an equipment shelter on top of the Montefiore Medical Center in the Bronx. That complicated the removal of the old transmitters and installation of the new transmitters.
This is the top of the Montefiore Medical Center in the Bronx. The building has 28 floors. To access the transmitter, one needs to go up another flight of stairs to the roof. Go outside onto the roof and take two more flights of stairs to the transmitter shelter just below the tower. Those stairs can be seen as a thin wispy thing on the left of the elevator building.
At the top of the tower, the two-bay Shively antenna is for WVBN 103.9 Mhz. WFUV 90.7 MHz is the six-bay Shively just below that.
These are the transmitters being replaced. There are two of them running combined for a TPO of 14.2 KW (including the -14 dBc HD subcarriers). They are about 20 years old.
As you can see, there is little room to work in this space. The old transmitters needed to be removed from the room, hosted down two stories to the main rooftop, wheeled around to the door, and then lowered another flight of stairs to the 28th to the elevator.
It makes me tired just thinking about it.
Out with the old, in with the new.
The GatesAir FAX15Ks made the trip up safely. Able Rigging from New Jersey did all of the moving into and out of the shelter. The two transmitter chassis, all of the boxes containing the exciters, RF modules, power supplies plus a 25 KW dummy load, and the cut-up for scrap Myat variable T antenna combiner were removed in one go.
The FAX15K’s are in the shorter cabinets (requires two) because the taller cabinet would not fit in the elevator.
The output of each transmitter goes to a 3-inch coax switch. The bottom port of the switch goes to the Shively filter (thence to the antenna), and the top port goes to the 20 KW dummy load.
I enjoyed working on this project.
