September 2010
M T W T F S S
« Aug   Oct »
 12345
6789101112
13141516171819
20212223242526
27282930  

Archives

Categories

RCA receiving tube manual, 1964 edition

RCA receiving tube manualI found this in the great clean out of 2010, Bridgeport, Connecticuit.  Once upon a time, I had a slightly newer version of this, I think from 1972 or so.  This version is from 1964 and gives a complete run down of most small tubes that were manufactured back then.

There is something about a well designed, well maintained piece of tube gear.  I remember an old Collins tube console that was in a production room at a small AM station.  The console went dead (paper clip shorted the B+) and I fixed it.

I recall listening to the test recording of my own voice from a reel to reel machine when I fixed the console.  It sounded better than I’d ever heard it, not that I have a great radio voice, by any means.

A tube is a voltage amplifier versus a transistor, which is a current amplifier.  A tube does not have the same fidelity as a transistor, as the voltage reaches it’s peak, it gets a little fuzzy, adding some distortion and harmonics.  Tube gear adds warmth, what a musician might call Timbre. The combination of fundamental frequency and varying amplitudes of harmonic frequencies that allow a listener to tell the difference between a piano and a guitar playing the same note.

This is what the current crop of tube mic preamps and other tube products tries to reproduce.  Several companies have come out with an amplifier design that has mostly transistors and one tube, usually a 12AX7.    Unfortunately, at least in my opinion, the fall a little short.  If you want to have the “tube sound,” it needs to be all hollow state.

What is intriguing to me are the schematic diagrams in the back of the book.  There is one for an audio amplifier:

RCA receiving tube manual audio amp schematic diagram C 1964

RCA receiving tube manual audio amp schematic diagram, C 1964

This is a single channel unit, for stereo, it would need to be duplicated.  Also, I would loose the tube rectifier in favor of a solid state full wave bridge, that would simplify T2 somewhat.  The OA2 could also be changed to a diode.  Looks like unbalanced audio in, which could be modified with an input transformer.

Another interesting diagram is this one, which can be used as a mic preamp:

Microphone Preamp schematic diagram RCA receiving tube manual C 1964

Microphone Preamp schematic diagram RCA receiving tube manual C 196

That looks like a pretty solid design, a few tweaks here or there to add some gain reduction and some type of output level adjustment and I would be a really cool piece of gear.  Again, the tube rectifier could be replaced with something solid state.  The output transformer would likely have to be changed to something like 600 ohms.

Couple that to something like this, the Collins 26U compressor/limiter, and one would have a great sounding microphone processor:

Collins 26U compressor limiter

Collins 26U compressor limiter

Looks pretty cool.  R10 is used to balance the two plate currents.  I would be interested in the transformer values, input/output impedances, voltages, etc.  The 6386 tube is very hard to find these days, a good substitute would be a 5670 which are still made by several manufactures.

Update:  This is a picture of a Collins 26-U sitting on my bosses floor.

Collins 26-U compressor limiter

Collins 26-U compressor limiter

A great online source for tube information is: Electron Tube Data Sheets.

If I have some time this winter, it may be a fun project to fool around with.

Axiom


A pessimist sees the glass as half empty. An optimist sees the glass as half full. The engineer sees the glass as twice the size it needs to be.

Congress shall make no law respecting an establishment of religion, or prohibiting the free exercise thereof; or abridging the freedom of speech, or of the press; or the right of the people peaceably to assemble, and to petition the Government for a redress of grievances.
~1st amendment to the United States Constitution

Any society that would give up a little liberty to gain a little security will deserve neither and lose both.
~Benjamin Franklin

The individual has always had to struggle to keep from being overwhelmed by the tribe. To be your own man is hard business. If you try it, you will be lonely often, and sometimes frightened. But no price is too high to pay for the privilege of owning yourself.
~Rudyard Kipling

Everyone has the right to freedom of opinion and expression; this right includes the freedom to hold opinions without interference and to seek, receive and impart information and ideas through any media and regardless of frontiers
~Universal Declaration Of Human Rights, Article 19

...radio was discovered, and not invented, and that these frequencies and principles were always in existence long before man was aware of them. Therefore, no one owns them. They are there as free as sunlight, which is a higher frequency form of the same energy.
~Alan Weiner

Free counters!